Cyclic Voltammograms of Ferrocene on Multi‐Walled Carbon Nanotubes (MWCNTs)‐Modified Edge Plane Pyrolytic Graphite (EPPG) Electrode in Room Temperature Ionic Liquids (RTILs) of 1‐Ethyl‐3‐Methylimidazolium Tetrafluoroborate (EMIBF4)

In this work, the electrochemical behavior of ferrocene (Fc) was investigated by cyclic voltammetry (CV) in room temperature ionic liquids (RTILs) of 1‐ethyl‐3‐methylimidazolium tetrafluoroborate (EMIBF₄) on glass carbon (GC), edge plane pyrolytic graphite (EPPG) and multi‐walled carbon nanotube (MWCNTs)‐modified EPPG electrodes, respectively. The results demonstrated that on GC electrode, pairs of well‐defined reversible peaks were observed, while for the electrode of EPPG, the peak potential separation (ΔE_p) is obviously larger than the theoretical value of 59 mV, hinting that the electrode of EPPG is distinguished from the commonly used electrode, consistent with the previous proposition that EPPG has many “defects”. To obtain an improved electrochemical response, multi‐walled carbon nanotubes (MWCNTs) were modified on the electrode of EPPG; the increased peak current and promoted peak potential separation not only proved the existence of “defects” in MWCNTs, but also supported that “creating active points” on an electrode is the main contribution of MWCNTs. Initiating the electrochemical research of Fc on the MWCNTs‐modified EPPG electrode in RTILs and verifying the presence of “defects” on both EPPG and MWCNTs using cyclic voltammograms (CVs) of Fc obtained in RTILs of EMIBF₄, is the main contribution of this preliminary work.     

Aza-Morita-Baylis-Hillman reactions of N-(benzylidene)polyfluoroanilines with methyl acrylate and acrylonitrile

Aza-Morita-Baylis-Hillman reactions of N-(benzylidene)polyfluoroanilines 1 with methyl acrylate or acrylonitrile were studied. It was found that Lewis base, solvent and reaction temperature can significantly affect the reaction. Using 3-hydroxyquinuclidine (3-HQD) as a Lewis base in the reactions of 1 with methyl acrylate in DMF, the normal aza-Morita-Baylis-Hillman adducts 3 were formed in moderate to excellent yields. For the reactions of 1 with acrylonitrile, 1,4-diazabicyclo[2.2.2]octane (DABCO) is the best Lewis base giving the corresponding aza-Morita-Baylis-Hillman adducts 4 as the sole product in good to moderate yield. However, upon treatment of 1 with acrolein 2c, the corresponding reaction did not occur even in the presence of a variety of catalysts.     

Interaction of 2-bromo-7-methyl-5-oxo-5H-1,3,4-thiadiazolo[3,2-α]pyrimidine with methylene-active compounds and acid hydrolysis of its products

Reactions of 2-bromo-7-methyl-5-oxo-5H-1,3,4-thiadiazolo[3,2-a]pyrimidine with sodium derivatives of pentane-2,4-dione, malonodinitrile, Meldrum acid, acetoacetic, cyanoacetic and malonic esters have been shown to give the respective substituted derivatives. Azinyl-ylidene tautomerism has been found to be characteristic of these compounds, the latter existing mainly in the ylidene form. The acid hydrolysis of pentane-2, 5-dione and cyanoacetic and malonic esters derivatives has been investigated.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 11, pp. 1957–1961, November, 1993     

Effect of surface treatment on the Hamaker constant of intermediate modulus carbon fibers

The Hamaker constant of unsized intermediate modulus carbon fibers was evaluated by contact angle measurement following the Fowkes theory of interfacial energetics. The effects of a surface treatment (performed by the manufacturer) and an oxygen plasma treatment (performed by us), both of oxidizing nature, proved to slightly increase the value of the Hamaker constant to a level that enhanced by about 9% the Lifshitz-van der Waals contribution to the theoretical adhesion force between the fiber and an epoxy matrix. A possible explanation of the observed increase of the Hamaker constant is the higher contribution to the overall Lifshitz-van der Waals interaction of Keesom (orientation) and Debye (induction) forces.     

Strukturen aus AIB2− und BaAl4−analogen Einheiten. I Die Verbindungen Sr4Pd5P5 und Sr2Pd3P3

Structures with AIB₂? and BaAl₄?type Units. I The Compounds Sr₄Pd₅P₅ and Sr₂Pd₃P₃ Sr₄Pd₅P₅ (Cmcm, a = 4.177(1) Å, b = 31.377(5) Å, c = 8.581(2) Å, Z = 4) und Sr₂ Pd₃P₃(Pmmm, a = 4.199(1) Å, b = 4.212(1) Å, c = 34.227(4) Å, Z = 4) have been prepared by heating the elements. Both structures contain exclusively units characteristic for the AIB_2? and BaAl₄?type. The ratio between isolated P-atoms and P₂?pairs is interpreted with an ionic splitting of the formulas.     

Infrared investigation of aluminum- and chromium-substituted magnetites and of the lacunar spinels resulting from their oxidation

When Fe³⁺ ions are substituted by aluminum or chromium on magnetite octahedral sites, the ir spectrum shows the conversion of an inverse spinel to a normal spinel. Both broad bands of magnetite are gradually replaced by the four characteristic bands of normal spinels II–III. They are also observed for solid solutions, FeCr₂O₄FeAl₂O₄, with, however, a further band at 780 cm^?1 which may be assigned to Al³⁺ ions on tetrahedral sites. Low-temperature (<400°C) oxidation of these compounds whose sizes are less than 2000 Å results in lacunar spinels III–III. The ir spectrum of these solids is characterized by two absorption bands (as for inverse spinels II–III) except for compounds close to pure γFe₂O₃ in which an order of vacancies could be put in evidence.     

2-[6-Alkyl-3-hetaryl-4-oxo-9,10-dihydro-4H,8H-chromeno-[8,7-<Emphasis Type="Italic">e</Emphasis>][1,3]oxazin-9-yl]acetic acids

The interaction has been studied of a series of substituted 3-hetaryl-7-hydroxychromones with amino acids and formaldehyde (reactants ratio 1: 1: 2 respectively). In the case of glycine and Het = 3-isoxazolyl the product of aminomethylation at position 8 of the chromone was obtained, and with other Het (including Het = 4-phenyl-1,2,4-triazol-3-yl) 2-[6-alkyl-3-hetaryl-4-oxo-9,10-dihydro-4H,8H-chromeno[8,7-e][1,3]-oxazin-9-yl]acetic acids were formed. With β-alanine and Het = 4-phenyl-1,2,4-triazol-3-yl the corresponding β-substituted propionic acid was synthesized, but proline did not participate in the reaction, leading to bis(6-ethyl-3-hetaryl-7-hydroxychromon-8-yl)methane. __________ Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 5, pp. 683–689, May, 2007.     

Ultrafast O2 activation by copper oxide for 2,4-dichlorophenol degradation: The size-dependent surface reactivity

This study demonstrated interesting ultrafast activation of molecular O₂ by copper oxide (CuO) particles and very rapid elimination of aqueous 2,4-dichlorophenol (2,4-DCP) within reaction time of 30 s. Electron paramagnetic resonance (EPR) characterization indicated that OH, Cu³⁺, ¹O₂ and O₂⁻ were generated in the CuO/O₂ systems, wherein O₂⁻ would be the main reactive species responsible for 2,4-DCP degradation. It was further found that the catalytic ability of CuO for O₂ activation was highly size dependent and nano-CuO was far reactive than micro-CuO. H₂ temperature-programmed reduction (H₂-TPR), X-ray photoelectron spectroscopy (XPS) and vibrating sample magnetometer (VSM) analyses revealed that both the quantity and the reactivity of the surface reaction sites (surface Cu⁺ and O₂) could determine the catalytic ability of CuO affecting efficient Cu⁺-based molecular oxygen activation. Moreover, the O₂ activation ability of CuO would depend on not only the dimension, but also crystalline factors, for example, the exposed facets.     

AES investigations on starting powders for high performance ceramics

AES depth profiles on ceramic powders (untreated/hydrolyzed/oxidized/ (Al, Y)₂O₃ coated Si₃N₄, [BaO, SiO₂] coated Al₂O₃) are feasible on thin, homogeneous layers or m sized agglomerations prepared on an Au foil. By means of the depth profiles one can qualitatively characterize the coating around the particles. Factor analysis of the depth profiles on the differently treated Si₃N₄ powders suggests the existence of an Si₂N₂O phase on the oxidized sample.Dedicated to Professor Günther Tölg on the occasion of his 60th birthday     

The reaction of phenylarsenazo with chromium(III)

The conditions for the reaction between phenylarsenazo (PAA) (2-[(2-arsonophenyl)azoj-7-(phenylazo)-1, 8-dihydroxynaphthalene-3,6-disulphonic acid) and chromium(III) have been studied. A blue 1:1 complex is formed at pH 2.2 on heating the reactants at 100 degrees for 15 min. It has maximum absorption at 635 nm and is stable for at least 24 hr. The molar absorptivity is 3.3 x 10(4) 1.mole(-1).cm(-1). Beer's law is obeyed in the chromium concentration range 0-1.4 mug ml . The reaction has been successfully applied to determination of chromium in alloy steel.